Wednesday, October 26, 2011

Install a Waterline For an Under The Counter Dishwasher

!: Install a Waterline For an Under The Counter Dishwasher

Installing a water line and drain pipe for an under the counter dishwasher is the same for a new dishwasher as it is for an old one. Once the location is chosen and the electrical works are connected, before the electricity is turned back on, install the water line and drain pipe for the dishwasher. Proper placement of water tubes and drain pipes will insure the dishwasher works correctly.

Be sure to have everything you need before starting to install the water line. The items needed are, a shutoff valve, the water line, a tape measure, a hand saw, a piece of copper tubing, a drain tube, a T-fitting, an adjustable wrench, and 4 compression fittings.

Before starting any work on the water line, be sure to shut off the water and empty the hot water line. Put a container under the hot water line and cut the line to install the T-fitting.

Place a compression fitting on each end. Tighten the fittings by hand, and then just a quarter turn with the adjustable wrench.

Attach the shutoff valve to the T-fitting. Secure the water line from the dishwasher to the shutoff valve.

Keep the container under the hot-water supply line. Turn the water back on. Look for leaks in all connections. Carefully tighten the connections a quarter turn at a time, if there is a leak. Once there are no leaks, time to move on to the drain hose.

Install the drain hose by measuring and cutting the drain tube to fit from the dishwasher to the drain. If attaching the drain hose through a garbage disposal, there will be space in the disposal to install a dishwasher drain pipe. If there is not a disposal, a waste T-fitting will need to be installed to attach to the drain.

Be sure to secure all connections before testing. Turn on the water and test again for leaks. If leaks are present, tighten the connections a little more, being careful not to over tighten. One quarter turn at a time, until the leak is stopped. Copper is a soft metal and will bend or break easily.

Once all connections are not leaking, finish installation of the dishwasher and run a test cycle. Check once again for any leaks. Once no leaks are found, installation is successful and finished. Place the dishwasher securely in its place.

If you have one, always refer to the installation manual for manufacturer specific installation.


Install a Waterline For an Under The Counter Dishwasher

Learn How Dyson Dc25 The Ball Book Ends Best Quality Where To Buy Electric Rechargeable Lawn Mower

Saturday, October 22, 2011

Clean the Ice and Water Dispenser on a Refrigerator Door

!: Clean the Ice and Water Dispenser on a Refrigerator Door

The ice and water dispenser on a refrigerator door is a very nice convenience. Over time, the ice and water outlets and the reservoir will get dirty and full of germs. The water reservoir on a refrigerator should be cleaned regularly to keep it clean and germ free. Cleaning the ice and water outlets should also be cleaned to insure it is clean and safe to dispense form. If the water reservoir is allowed stay wet and dirty, it can look and smell terrible. A little skill is needed to clean the outlets and the reservoir. Only safe cleaners should be used to clean the ice and water dispensing parts.

Gather the necessary supplies and get cleaning. White vinegar, a 1 cup measuring cup, a screwdriver, some gray tape and an old toothbrush should get the job done.

The very first thing to do is unplug the refrigerator and turn the water supply to the refrigerator to the off position. Unscrew the screw that is holding the copper water supply tube in place. Slide the copper tube out of position.

Holding the tube upright, pour about 3 cups of vinegar into the tube. Hold the tube over the reservoir to catch any overflow. Leave the vinegar sit for 5 minutes in the tube and the reservoir.

Using grey tape, attach the copper tube to the back of the refrigerator to keep the vinegar draining down towards into reservoir.

Empty the ice dispenser by depressing the ice dispenser lever to expel all of the ice. Let about half of the vinegar flow through to flush out any dirt.

Next, depress the water lever on the water dispenser. This will allow the vinegar to run through the water supply pipes and tubes getting a complete cleaning. Keep the button pressed until all the vinegar has ran through into the reservoir. If the reservoir is small, empty it as it gets full.

Dip a toothbrush into the vinegar in the reservoir. Scrub the spouts that the ice and water flows through with the old toothbrush. Continue scrubbing with the toothbrush. Be sure to clean the entire ice and water dispensing center with vinegar. Pay close attention to the corners of the reservoir.

Remove the reservoir tub. Rinse well in the sink with warm water. Replace.

Place the copper tubing back in its space. If the refrigerator was moved, return it to position. Turn the water supply back on. Run fresh water through the ice and water spouts for a few minutes to rinse all vinegar out.


Clean the Ice and Water Dispenser on a Refrigerator Door

Good Bargain Installing Drip Irrigation System Lawn Mower Battery Powered Ideas Information Dinosaur Baby Bedding

Monday, October 17, 2011

Oakley Kitchen Sink Pack, Black

!: Used Oakley Kitchen Sink Pack, Black discount

Brand : Oakley
Rate :
Price : $170.00
Post Date : Oct 17, 2011 10:24:15
Usually ships in 1-2 business days



Oakley combined all the best features from their individual backpacks for the Kitchen Sink Pack. This bag gets its name from the one item you might not be able to carry inside it. A compression molded top pocket protects valuables like sunglasses and small electronics and features a headphone port for media players. Throw your cell in the dedicated phone pocket and rest assured knowing your 17-inch computer is safe in the padded laptop sleeve. The interior organizer keeps things from getting chaotic inside the Kitchen Sink Pack. A self-draining, waterproof compartment is ideal for wet board shorts or gym gear, and a plethora of exterior pockets and tie downs take care of the rest.

Product Features

  • Material: nylon
  • Volume:
  • Pack Dimensions:
  • Laptop Pocket Size: up to 17 in
  • Pockets:
  • Waist-Belt: yes
  • Waist-Belt Type:
  • Back-Panel Access:
  • Skateboard Carry: no
  • Weight:
  • Recommended Use: school, casual
  • Manufacturer Warranty: 30 days

Ranco 211000 Guide


Twitter Facebook Flickr RSS



Français Deutsch Italiano Português
Español 日本語 한국의 中国简体。